ABB 800xA Operation page 311

Appendix A Runtime Templates
OSP VALUE 01 through 16
Enter the channel value (0 or 1) to output after an OSP TIMEOUT. If the OSP
HOLD has been selected as the OSP value then this field entry is ignored.
The valid values are:
0 or 1.
Where 0 = off and 1 = on.
The default is 0.
POSITION
Enter a number from 1 to 12 representing the position of the I/O module relative to
the FCI. The I/O module directly next to the FCI is number 1.
Default value is 1.
REPORT FAULTS 01 through 16
If channel faults are to be reported, enter a YES;
if not enter a NO.
The default value is YES.
RESERVED OPTIONS
Used to select I/O module type:
Enter:
0 (zero) for the DO810 Module
542769152 for the DO890 Module (decimal value for all channels without
supervision) see table below where a "1" sets supervision for channels 4 - 1.
3BUR002418-600 A
DO810
311