9.22 Main PCB shield
(1) Remove the screw pan (S washer) M3x10 screw from the right side of machine.
(2) Remove the two taptite bind B M3x10 (black) screws to remove the main PCB shield.
Main PCB shield
Assembling Note:
• When attaching the main PCB shield, insert the five tabs to each groove.
• Pass the first side CCD flat cable and multi-feed sensor PCB flat cable (Receive)
through the two holes of the main PCB shield.
Screw pan (S washer) M3x10
Fig. 3-56
Tabs
Taptite bind B M3x10 (black)
Fig. 3-57
3-46
Multi-feed sensor PCB flat cable (Receive)
First side
CCD flat
cable
Holes
Confidential