Multi-Feed Sensor Pcb (Receive) / Multi-Feed Sensor Pcb Flat Cable (Receive) - Brother PDS-5000 Service Manual

9.29 Multi-feed sensor PCB (Receive) /
Multi-feed sensor PCB flat cable (Receive)
(1) Remove the two taptite bind B M3x10 (black) screws to remove the multi-feed sensor
PCB (Receive).
(2) Disconnect the multi-feed sensor PCB flat cable (Receive) from the multi-feed sensor
PCB (Receive).
Note:
• After disconnecting flat cable, check that the cable is not damaged at its end or
short-circuited.
• When connecting flat cable, do not insert it at an angle. After insertion, check that
the cable is not at an angle.
Multi-feed sensor PCB flat cable (Receive)
Harness routing: Refer to
Taptite bind B M3x10 (black)
Fig. 3-71
"1. Main PCB ASSY".
3-55
Multi-feed sensor PCB (Receive)
Confidential