Table of Contents
Advertisement
IDS1000 Container Data Center
User Manual
Figure 3-1 Setting passive output for alarms
You must perform the jumper operation. Otherwise, the 6 A fuse (5D) on the main board will
be damaged.
The factory setting of the jumper mode on the fire extinguishing controller for the single
alarm, composite alarm, and general fault is active output, as shown in
Issue 01 (2014-3-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Power-On Commissioning
Figure
3-2.
13
Advertisement
Table of Contents
