Siemens SINUMERIK 840D sl Programming Manual page 106

Measuring in JOG
4.2 Workpiece measurement
after activating the selected ZO assumes the required setpoint position (e.g. X0) in the
corrected workpiece coordinate system.
Note
• The rejection, repetition, and end of measurement are described in the "Reject, repeat,
• A support function is available to the user when activating the determined ZO correction
See also
Rejection and repetition of measurements (Page 4-35)
General information (Page 4-38)
4-18
end of measurement" chapter.
in the JOG mode. This is shown right after the measurement and is detailed in the
Measuring workpieces chapter, "Support of set-up in JOG - after measurement".
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles