Measuring A Workpiece At An Angle - Siemens SINUMERIK 840D sl Programming Manual

General
1.12 Overview of measuring cycle functions for milling technology
1.12.5

Measuring a workpiece at an angle

The following measuring variants are provided for the measurement of a hole, shaft, groove,
or web at an angle. They are executed by CYCLE979.
Three- or four-point measurement at an angle
Result:
• Actual dimension, deviation: Diameter, center point
• Deviation: Tool offset of the zero offset
Two-point measurement at an angle
Result:
• Actual dimension, deviation: Groove, web width, groove, web center
• Deviation: Zero point offset
1-38
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles