Step 1 - Load Definition Files; Step 2 - Load Other Archive - Siemens SINUMERIK 840D sl Programming Manual

10.7.3.2 Step 1 – load definition files
Save data to the archive or floppy disk using "Services", "Data out", folder "NC-active data",
"User data". Select the GUD5.DEF, GUD6.DEF and if necessary GUD7_MC.DEF modules
singly in the area "Services", "Manage data", in the folder "Definitions" and press softkey
"Unload NC → HD".
Load the archive specified for each measuring cycle release using "Services", "Data in",
"Archive", "Cycles archive", "Measuring cycles" (\ARC\CYC\MCYC.DIR):
• With meas. cycles SW 6.2:
Notice
Only load the JOGDEF.ARC archive if ShopMill is not installed!
• With meas. cycles SW 6.3
Select the GUD5.DEF and/or GUD6.DEF modules singly in the area "Services", "Manage
data", in the folder "Definitions" and press softkey "Activate".
• Only for measuring in JOG
Select the GUD7_MC.DEF module in the area "Services", "Manage data", in the folder
"Definitions".
Press softkey "Load HD → NC".
Then select module GUD7.DEF and press softkey "Activate".
The following questions:
"Do you want to activate the definitions from file GUD7.DEF?" and if required "Should the
previous values for the definitions be retained?" on HMI should be answered with "Yes".
Load the saved user data again via "Services", "Data in".
10.7.3.3 Step 2 – load other archive
Note
Refer to Chapter 10.4.3 Step 2.
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
DEFINES.ARC Archive with definition files (GUD5.DEF, GUD6.DEF)
JOGDEF.ARC Archive with definition file (GUD7_MC.DEF)
DEFINES.ARC Archive with definition files (GUD5.DEF, GUD6.DEF,
GUD7_MC.DEF)
JOGDEF.ARC Empty archive which does not have to be loaded.
Start-up (hardware)
10.7 Upgrading measuring cycles
10-23