Siemens SINUMERIK 840D sl Programming Manual page 510

Appendix
A.1 Overview of measuring cycle parameters
CYCLE997
Parameter Type
GUD5
_FA
REAL
>0
_INCA
REAL
_KNUM
INT
_MVAR
INT
>0
_NMSP
INT
>0
_PRNUM
INT
>0
A-20
Workpiece measurements
1 sphere
Incremental angle (for _MVAR=xx1109 only, measuring at an angle)
1..99
automatic offset in ZO
G54...G57
G505...G599
1000.
automatic offset in basic frame
G500
1011...1026
automatic ZO correction in 1st to 16th
channel basic frame
1051...1066
automatic ZO correction in 1st to 16th global
basic frame
2000
automatic ZO correction in system frame
9999
automatic ZO correction in active frame
G54...G57,G505...G599 or with active G500
in the last active channel-specific basic frame
x0xxxx
(number of the data field assigned to the workpiece probe
Possible measurements
G17: X-Y plane
G18: Z-X plane
G19: Y-Z plane
Measuring with automatic ZO correction
Measurement path in mm
without/with automatic offset of the ZO memory
0 without offset
1..99
automatic offset in ZO
G54...G57
G505...G599
1000
automatic offset in basic frame G500
1011...1026
automatic ZO correction in 1st to 16th channel
basic frame
2000
automatic ZO correction in system frame
9999
automatic ZO correction in active frame
G54...G57,G505...G599 or with active G500 in
the last active channel-specific basic frame
Measuring variant
Number of measurements at the same location
Workpiece probe number (for multi probe only)
Values: 1 to maximum 99
GUD6:_WP[_PRNUM–1]
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
1 sphere
x1xxxx
Measuring cycles