Siemens SINUMERIK 840D sl Programming Manual page 258

Measuring Cycles for Milling and Machining Centers
5.8 CYCLE961 workpiece: Setup inside and outside corner
The workpiece corner is expected to be at a distance less than 200 mm at each point
(_FA=100 [mm]).
Workpiece probe 1, used as tool T9, D1, is
to be used.
The probe is already calibrated. Arrays for
workpiece probe 1: _WP[0, ...]
The following is entered under T9, D1 in
the tool offset memory:
Tool type (DP1):
Length 1 - geometry (DP3):
Radius - geometry (DP6):
Length 1 (L1) must refer to the center of
the probe ball (_CBIT[14]=0), as for
calibration.
Careful when positioning! Radius R in
length (L1) is ignored.
%_N_CORNER_SETUP_1_MPF
N10 G54 G17 G90 T9 D1
N20 G0 Z100
N30 X100 Y70
N50 _MVAR=118 _SETV[0]=50 _SETV[1]=20
_SETV[2]=150 _SETV[3]=20 _SETV[4]=15
_SETV[5]=40 _SETV[6]=15 _SETV[7]=80
_ID=-60
N51 _VMS=0 _NMSP=1 _PRNUM=1 _FA=100
_KNUM=2
N60 CYCLE961
N70 G55
N80 G0 X0 Y0
N100 M2
5-124
710
L1 = 50.000
R = 3.000
;Select ZO, plane, probe, ...
;Position probe at positioning height
;Position probe in X/Y plane above
;workpiece
;Measuring variant for external corner
;coordinates of P1 to P4
;Measurement path 100 mm to expected edge
;(max. measurement path =200 mm)
; Cycle call
;Call corrected ZO G55
;Position probe in X/Y plane above
;corner (new zero point)
;End of program
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles