Configuration And Programming In Step 7 / Via Tia Portal; Profinet Integration Via Gsd File; Profibus Integration Via Gsd File - Siemens SIDOOR ATD4 W Series System Manual

Configuration and Programming in STEP 7 / via TIA
Portal
Configuration
The configuration of the control unit ATD420W on PROFIBUS or ATD430W on PROFINET is made
via certified GSD files. This ensures compatibility with different industrial automation systems.
Before configuring, you must import the relevant GSD file into the configuration tool, for
example STEP 7.
Programming
A function block is provided for quick and easy connection of an SIDOOR drive to a SIMATIC
controller via PROFIBUS or PROFINET communication.
9.1

PROFINET integration via GSD file

Install the GSD file (see GSD files
103949094)) in the applicable configuration tool before configuring the SIDOOR ATD430W
PROFINET controller.
After installation, you will find the ATD430W controller under the following category:
"PROFINET IO > Drives > SIDOOR"
Note
Configuration notes
• Modify the Ethernet or PROFINET settings according to the applicable system.
• Make sure that the I/O addresses start at the same value.
• When the system is configured, the device parameters are assigned the following default
values specified by the GSD:
Cycle time [ms]: "100"
You can find additional information on the supported PROFINET functions and protocols in the
PROFINET module (Page 149) and PROFINET communication (Page 157) sections.
9.2

PROFIBUS integration via GSD file

Install the GSD file (see Industry Online Support
support.industry.siemens.com/cs/ww/en/view/99008084)) in the applicable configuration tool
before configuring the SIDOOR ATD420W PROFIBUS controller.
After installation, you will find the ATD420W controller under the following category:
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA
(https://support.industry.siemens.com/cs/ww/en/view/
(https://
9
285