Fault Management - Siemens SIDOOR ATD4 W Series System Manual

Diagnostic and maintenance

11.2 Fault management

Display Meaning
5 New motor type detected - learn run is required
P Parameter error (error during learn run)
y Master timeout
_ Controller has no parameters and is waiting for learn run
a As of V1.12: Discrepancy error occurred with AND0 or AND2 (Discrepancy analysis blocks (Page 99))
Reserve
b –
h –
See section SIDOOR functions (Page 43)
1)
11.2 Fault management
Faults
Faults are all occurring system errors that require acknowledgment.
You will find a list of faults in the section Operating state display (Page 303).
SIDOOR ATD401W
Automatic fault acknowledgment. You can activate the automatic acknowledgment of faults in
the service menu via the menu item "General setup -> Special parameters -> Automatic restart".
SIDOOR ATD420W / ATD430W
The system responds to faults according to the control unit (see Figure 5-4 Sequential control
state graph (Page 163)). After acknowledgment, the control unit automatically triggers a reset
after a protection time of 5 s.
Fault acknowledgment
The fault acknowledgment can be carried out with one of the following four possibilities:
• Corresponding terminal input prompt
• FBLOCK "Error acknowledgment"
• Corresponding acknowledgment bit (bit 7) in the STW1 (see section STW1 - control word
(CtrlW) (Page 317))
• Automatic, through activation of the "Automatic restart" using the service menu (see "Special
parameters", chapter 7.4 navigation structure ...) or through logic operation of the FBLOCK
signal "Fault" (Q37) with the error acknowledgment (p20119).
SIDOOR ATD420W / ATD430W
1)
If "FBLOCK + relay" (p100=1) is set in the service menu under "General setup > Special
parameters > Std. command input", the relay outputs Open and Close are active if a fault occurs.
(See e.g. Table 4-5 (Page 137) in section Relay module)
304
1)
1)
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA