Emergency Power Mode; Basic Parameter Editor (As Of V1.10) - Siemens SIDOOR ATD4 W Series System Manual

SIDOOR functions
4.3 Extended functions
The distances required for acceleration and braking also have to be taken into account for speed
changes.
4.3.9.14

Emergency power mode

SIDOOR ATD420W / ATD430W:
Description of function
If the mains voltage fails and the emergency power supply is active, the door controller can be
switched to emergency power mode via the "Emergency power mode" FBLOCK function block,
see section 3.3.9 Free function blocks (Page 92). This function can be implemented, for
example, by means of a UPS with an appropriate output signal.
Parameter assignment
The FBLOCK function block "Emergency power mode" (p20120) has to be connected with a
signal which shows the activation of the emergency power supply. This can, for example, be a
digital input signal (DI0 to DI4), a control bit (SBIT0 to SBIT4) or the output signal of another
function block.
In emergency power mode, a speed-reduced driving curve profile is used. Emergency power
mode cannot be exited until the controller has reached the closed or open state in normal mode.
4.3.10

Basic parameter editor (as of V1.10)

Function description
The parameters determined in a test run can be set using a fieldbus or the control menu. These
parameters are called "basic parameters (Page 186)".
The basic parameters editor can be used to perform initial commissioning of a door control unit
only by setting parameters without a learn run.
For example, the parameter set can be determined once for identical door systems. Each door
control unit is configured with this parameter set at the factory. When replacing a door control
unit, the parameter set can be copied from the old control unit to the new control unit.
It is recommended to determine the basic parameters for a door system once with a learn run
and then to adapt or copy it to other door control units.
106
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA