Developer Assembly And Drum Unit Installation - Toshiba DP125F Operator's Manual

Developer Assembly and Drum Unit Installation

1 2
Open the Top Cover
Top Cover
Release Lever
037 040
Grasp the Top Cover Release Hold the Developer Assembly
Lever to open the Top Cover. with both hands and shake the
cartridge back and forth several
times.
3
Shake the Developer Remove the
Assembly Protective Strip
Developer
Assembly
Developer
Assembly
Holding the Developer Assem-
bly with one hand, grasp the
end of the protective strip under
the Toner Cartridge. Pull the
strip firmly to completely remove
it from the Toner Cartridge.
• The sealing film will contain
a small amount of toner on
its surface.
Carefully dispose of the film
in an appropriate waste re-
ceptacle
items it may come in contact
with.
Attach the Drum Unit
4
to the Developer
Assembly
Drum Unit
Strip
041 042
Attach the Drum Unit to the De-
veloper Assembly. Position the
Drum Unit with the green Drum
surface facing the Toner Roller
on the Developer Assembly.
IMPORTANT:
• Never touch the photo-
conductive
green surface) of the
Drum Unit. If the surface
is scarred or scratched, it
to avoid soiling will cause print quality
problems.
• Do not expose the photo-
conductive drum of the
Drum Unit to light for
more than 3 minutes. If
the Drum Unit is to be left
anywhere outside the fac-
simile, be certain to cover
it with cloth, paper, etc.
Install the Developer
5
Assembly with Drum
Unit
Developer
Assembly
Developer
Assembly
Install the Developer Assembly
(with Drum Unit attached) into
the machine.
Holding the Developer Assem-
bly by the green handles, align
the three shafts on the Devel-
oper Assembly sides with the
drum (the slots in the machine frame.
043
25