Document Loading - Toshiba DP125F Operator's Manual

Document Loading

1 2
Remove Attached
Items
073
Remove any staples, paper Up to 50 sheets (Letter-size)
clips, or other items from your can be loaded and sent at a
document before feeding it into time.
the facsimile.
Stagger the leading edges of
When scanning Legal-size doc- the sheets slightly and insert
uments, extend the Exit Docu- them into the document feeder.
ment Tray Extension.
88
Place Document Pages on the Document Tray
About 45°
Document Face Side
074 110
Adjust the Document Guides to
fit the width of the document.
Load the document face down
on the document tray. The first
page of your document should
be at the bottom of the Docu-
ment Tray.
Gently insert the leading edge of
the paper into the facsimile as
shown. The facsimile waits 2
seconds, then pulls the docu-
ment into the scanning area and
stops.
When a Carrier Sheet is used,
documents must be sent one
page at a time (manually fed).
When the document sheet is
longer the Document Tray, as-
sist it with your hand to insure
proper feeding.
3
Adjust the Settings
After the facsimile pulls the
document into the scan position
slightly and stops, you may
change the resolution and con-
trast settings. (It may also be
changed before or during the
document loading.)
To cancel a document already
set and pulled in, press:
If your document is extremely
dark or light, or if it contains
photographs, you may wish to
adjust the contrast and resolu-
tion settings. See the following
pages.