Figure 2-49 Removing The L-Bracket - NEC SL1000 Hardware Manual

SL1000
2. Loosen two screws and remove the L-Bracket.
Two screws
(M4 X 8)
3. Turn the L-Bracket upside down.
Rotate the L-Bracket 180 degrees so that the upper FACE as shown in above figure "Removing
the L-Bracket" is Located at the bottom as shown by below figure "Securing the L-Bracket and
WM Hook".
4. Insert tabs on Battery Box into holes on L-Bracket.
Secure the L-Bracket to the Battery Box using two screws.
5. Using two screws (M4x8), secure the WM Hook to the L-Bracket.
6. Using two anchor bolts (locally procured), secure the WM Hook to the wall.
The WM Hook securing must be required both Floor mount and Wall mount cases.
2-32

Figure 2-49 Removing the L-Bracket

ISSUE 1.0
L-Bracket
Installation