Mounting The Expansion Interface Card; Mounting The 408E-A1/008E-A1/000E-A1/1Priu-C1 Pcbs; Figure 2-63 Removing The Sub-Cover - NEC SL1000 Hardware Manual

SL1000
Items
IP4WW-2BRIDB-C1
IP4WW-1PRIU-C1

3.3 Mounting the Expansion Interface Card

DO NOT POWER ON until all installations have been completed.
Fit the optional 2BRIDB-C1 daughter boards before installing the 000E-A1/008E-A1 PCBs. Set the switches on
the 2BRIDB-C1 board before mounting it onto the 000E-A1/008E-A1 PCB.

3.3.1 Mounting the 408E-A1/008E-A1/000E-A1/1PRIU-C1 PCBs

The procedure for mounting the expansion interface cards is as follows;
• Do Not Power on until all installation have been completed.
• If the Expansion KSU(s) is/are installed, turn the power on/off in the order of
Exp 3 KSU, Exp 2 KSU, Exp 1 KSU and then Main KSU.
1. Turn off the system power and disconnect the AC cord from KSU.
2. Open and pull out the Sub-cover.
2-40
List of Contents
2BRIDB-C1 PCB
Nylon Spacers
2BRI Label
Metal Spacers
Screws (with circular washer)
1PRIU-C1 PCB (with PKG Spacer)
Nylon Spacers
Metal Spacers
Screws (with circular washer)
Sub-Cover

Figure 2-63 Removing the Sub-cover

Sub-Cover
Tab
ISSUE 1.0
QTY
1
2
1
1
2
1
2
2
2
Tab
Installation