Gear Pump - Toro Reelmaster 7000-D Service Manual

Gear Pump

18
3
8
12
8
5
26
11
10
1. Flat washer (2)
2. Cap screw (2)
o
3. 90 hydraulic fitting
4. Straight hydraulic fitting
5. O- ring (4)
6. Gear pump assembly
7. Piston pump assembly
o
8. 90 hydraulic fitting (2)
9. Coupler
Removal (Fig. 50)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Raise seat and secure it with prop rod to gain access
to gear pump.
Hydraulic System
77 to 93 ft- lb
(105 to 126 N- m)
18
13
11
17
16
1
2
11
19
20
24
5
25
o
10. 90 hydraulic fitting
11. O- ring
12. O- ring (4)
o
13. 45 hydraulic fitting
14. Cap screw (2)
15. Washer (2)
16. O- ring (2)
17. Spacer
18. O- ring (2)
14
7
9
16
23
22
21
6
Figure 50
3. Drain the hydraulic reservoir into a suitable contain-
er.
4. To prevent contamination of hydraulic system during
removal, thoroughly clean exterior of pump and fittings.
Page 5 - 92
15
5
4
12
23
103 to 118 ft- lb
(140 to 160 N- m)
22
21
19. O- ring
20. Hydraulic junction fitting
21. O- ring (2)
22. Straight hydraulic fitting (2)
23. O- ring (2)
24. O- ring
o
25. 90 hydraulic fitting
26. Straight hose fitting
Reelmaster 7000- D
RIGHT
FRONT