Brake Inspection And Repair - Toro Reelmaster 7000-D Service Manual

Brake Inspection and Repair

2
1
15
14
13
12
1. Brake housing (LH shown)
2. Seal
3. Pull rod
4. Clevis pin (2)
5. Link (2)
Brake Inspection and Repair (Fig. 3)
1. Carefully scrape gasket material (item 10) from
brake housing and planetary wheel drive mounting sur-
faces.
2. Remove retaining ring (item 9).
3. Remove stationary discs (item 7) and rotating discs
(item 8).
4. Remove extension springs (item 12).
5. Remove pull rod assembly (items 3, 4, 5 and 6).
Axles, Planetaries and Brakes
3
4
5
11
Figure 3
6. Hitch pin (2)
7. Stationary disc (4)
8. Rotating disc (3)
9. Retaining ring
10. Gasket
Page 7 − 10
6
7
8
11. Rotating actuator
12. Extension spring (3)
13. Ball (3)
14. Plug
15. O−ring
6. Remove actuator and balls (items 11 and 13).
7. Remove seal (item 2) from brake housing.
8. Wash parts in cleaning solvent. Inspect components
for wear or damage.
9. Reverse steps 2. − 7. to assemble brakes, installing
new parts as necessary. Install a new seal (item 2).
10.Use a new gasket (item 10) and gasket sealant when
installing brake assembly to machine.
Gasket Sealant
9
10
Reelmaster 7000−D