Specifications; Specifications - Toro Reelmaster 7000-D Service Manual

Specifications

Frame Construction: Precision machined die cast alu-
minum cross member with bolt--on cast ductile iron or
aluminum side plates.
Reel Construction: Reels are 27 inches (69 cm) in
length and 7 inch (18 cm) in diameter. High strength, low
alloy steel blades are thru hardened and impact resis-
tant. Reels are available in 8 and 11 blade configura-
tions. Optional 32 inch (81 cm), 8 blade reels are
available for the rear cutting unit positions.
Reel Bearings:
Cutting units with painted side plates have two
double row, self--aligning ball bearings press fit onto
reel shaft with inboard seal for protection. Reel bear-
ing adjustment is maintained by an adjuster nut in the
left side plate of the cutting unit.
Cutting units with aluminum side plates have two
stainless steel sealed radial ball bearings pressed
onto the reel shaft. Reel end play is maintained by an
internal wave spring (no adjustment required).
Reel Drive: The reel weldment shaft is a 1 5/16 inch
(33.3 mm) diameter tube with drive inserts threaded into
both ends. The reel drive inserts have an internal nine
(9) tooth spline.
Height- -of- -Cut (HOC): Cutting height is adjusted on
the front roller by two (2) vertical screws. Effective HOC
may vary depending on turf conditions, type of bedknife,
roller type and installed attachments.
DPA Cutting Units
Figure 1
Bedknife: Replaceable, tool steel EdgeMax
is fastened to a machined cast iron bedbar with 10
screws. Optional bedknives are available.
Bedknife Adjustment: Dual screw assemblies allow
for precise bedknife adjustment. Adjustment detents
correspond to bedknife movement of 0.0009 inch (0.022
mm) for each indexed position.
Front and Rear Rollers: Greaseable through--shaft
front and rear rollers are used with these cutting units.
All rollers use the same heavy duty, stainless steel ball
bearings and seal package.
Counterbalance Weight: A cast iron weight or a
groomer and/or a powered rear roller brush accessory
is mounted opposite to the hydraulic drive motor to bal-
ance the cutting unit.
Cutting Unit Weight:
27" Reel, 8 Blade
27" Reel, 11 Blade
32" Reel, 8 Blade (optional) 191 lb. (87 kg)
Options:
Refer to Cutting Unit Parts Catalog for available options
for your Reelmaster DPA cutting unit.
Page 9 - - 2
bedknife
TM
170 lb. (77 kg)
175 lb. (79 kg)
Reelmaster 7000--D