Toro Reelmaster 7000-D Service Manual page 247

Number/
Code
160
161 Engage Cutting Unit Denied
162 Lower Cutting Unit Denied
163 HIGH (transport speed range) Denied
169 Engine Shutdown
170 Recycle Keyswitch (ignition switch)
171 Auto Idle Engaged
(Yanmar diesel engines only)
173 Master Address Claim (TEC)
176 Reel Speed Changed
177 Reel Speed Changed Out of Range
179 Ash Cleaning Warning
180 New Value Saved in Permanent Memory
Engine running
Version check restriction
or
Sit down or set parking brake
Not in neutral
Raise switch closed
Lower switch closed
Not in seat
Range high engaged
Coolant too hot
Reelmaster 7000−D
Description
Start Denied
Table 1: Operator Advisories
Table 2: Operator Advisory Qualifiers
Page 6 − 21
Condition/Action
Wait to start until system functions have been initialized
No operator in seat and parking brake is not engaged.
Traction pedal is in FORWARD or REVERSE position
Joystick is in RAISE position
Joystick is in LOWER position
Reel Enable/Disable switch is in ENGAGE position
No operator in seat
Engine coolant temperature is excessive
Speed limiter is in HIGH (transport) position
Cutting unit position switch is closed (cutting units be-
low turnaround position).
No operator in seat and parking brake is not engaged.
Parking brake IS engaged while traction pedal is in
FORWARD or REVERSE position
Engine coolant temperature is excessive
Engine oil pressure is low
Engine starter motor has been engaged for more than
30 seconds or engine start attempt already happened
Engine RPM has been reduced to low idle speed as
machine has been inactive for the set period of time.
Inactive means the traction pedal is in NEUTRAL, reel
enable/disable switch is in DISENGAGED position, joy-
stick is in NEUTRAL position, and engine speed switch
(Yanmar diesel engines) is not pressed.
Auto idle feature timing can be reduced, increased, or
turned OFF as needed.
An item on the Setting Screen used to calculate reel
speed has been changed
See Yanmar diesel engine Service Manual
An item on the Setting Screen has been changed
Hydraulic oil too hot
Reel Enable/Disable switch enabled
Parking brake is set
Loss of CAN
Key start held too long
Safety kill
Recycle keyswitch
Engine Oil Pressure Low
Electrical System