Adjustments
HI/LOW (transport/mow) Switch
The HI/LOW switch is a normally open proximity switch
mounted to a bracket under the footrest platform
(Fig. 26). When the speed limiter is moved to the HIGH
(transport) position, a tab on the speed limiter swings in
front of the switch, closing the switch. The HILOW switch
provides an input for the Toro Electronic Controller
(TEC) during various machine operation modes.
Adjustment
1. The gap between the HI/LOW switch and the mow
speed limiter should be from 0.040" to 0.100" (1.1 to
2.5 mm).
2. If gap is incorrect, loosen jam nuts that secure switch
to footrest platform. Position switch with jam nuts to al-
low correct gap between switch and mow speed limiter.
Tighten jam nuts to secure adjustment. Jam nuts should
be torqued from 13 to 17 ft−lb (17.6 to 23.0 N−m). After
jam nuts are tightened, make sure that clearance be-
tween end of HI/LOW switch and the mow speed limiter
has not changed.
3. Check for proper HI/LOW switch operation after ad-
justment (see HI/LOW switch testing in this chapter).
Reelmaster 7000−D
SPEED LIMITER SHOWN IN HIGH
(TRANSPORT) POSITION
1. HI/LOW switch
Page 6 − 33
VIEWED FROM ABOVE
1
0.040" to 0.100"
(1.1 to 2.5 mm)
Figure 26
2. Speed limiter
Electrical System
2