Worklight Bulb Replacement - Toro Reelmaster 7000-D Service Manual

Worklight Bulb Replacement

The worklights are adjustable left and right, and up and
down as necessary. The worklights use a replaceable
halogen bulb.
CAUTION
The worklights use a halogen bulb that becomes
extremely hot when in operation. Handling a hot
bulb can cause severe burns and personal injury.
Allow enough time for bulb to cool before han-
dling.
Bulb Replacement (Fig. 73)
1. Park machine on a level surface, stop engine, apply
parking brake and remove key from ignition switch.
2. Remove screw securing bezel to worklight body and
remove bezel.
3. Disconnect worklight from wire harness at bulb and
remove worklight.
4. Loosen the bulb from the worklight by rotating it 1/4
turn counter−clockwise. Then, grasp bulb base and re-
move bulb from the worklight.
CAUTION
Any surface contamination can damage the
halogen bulb and lead to its failure or explosion
creating a serious safety hazard.
Halogen bulbs should be handled without touch-
ing the clear bulb surface. Handle the bulb by
holding onto the base.
5. Align tabs on bulb with notches in headlight opening.
Insert bulb into back of headlight without touching the
glass bulb surface. Secure bulb to worklight by rotating
it 1/4 turn clockwise.
Electrical System
4
3
1. Body
2. Screw
3. Bezel
6. Connect worklight to wire harness at bulb.
7. Install worklight, bezel, and screw.
8. Adjust/aim worklight as needed.
Page 6 − 68
5
2
Figure 73
4. Worklight
5. Bulb
Reelmaster 7000−D
1