Toro Reelmaster 7000-D Service Manual page 417

5. If groomer reel is equipped with broomer kit (Fig. 14),
position broomer brushes to reel blades and secure with
straps. Straps should be positioned between blades
2
2
1−2, 14−15, 28−29 and 41−42. Pull straps tight and cut
2
off strap extension approximately 1/4" (6 mm) beyond
2
retainer.
1
6. Place excluder seals on groomer shaft.
7. Install O−ring on non−drive end of groomer shaft.
8. Install groomer reel back on cutting unit (see Groom-
er Reel Installation in this section).
Figure 14
1. Groomer shaft 2. Broomer strap
Reelmaster 7000−D Page 10 − 13 Belt Driven Groomer (Optional)