Toro Electronic Controller (Tec) - Toro Reelmaster 7000-D Service Manual

Hide thumbs Also See for Reelmaster 7000-D:
Table of Contents

Advertisement

Toro Electronic Controllers (TEC)
Reelmaster 7000−D machines use a Toro Electronic
Controller (TEC) to control electrical system operation.
The controller contains a microcontroller that monitors
the condition of various switches and senders (inputs).
The controller then directs electrical power to control ap-
propriate machine functions (outputs) based on the in-
put conditions. The controller is attached to a bracket
under the operator seat (Fig. 31).
Logic power is provided to the controllers as long as the
battery cables are connected to the battery. A 2 amp
fuse (F−D1) provides circuit protection for the logic pow-
er to the controller.
The electrical power for controller outputs is provided
through three (3) connector terminals (PWR 2, PWR 3
and PWR 4). Three (3) 7.5 amp fuses (F−A1, F−B1, and
F−C1) provide circuit protection for the controller out-
puts.
The TEC monitors the states of the following compo-
nents as inputs:
Input Number
IN 1
Parking Brake Switch OFF
IN 2
Cutting Unit Position Switch
IN 3
IN 4
IN 5
HIGH/LOW (transport/mow) Switch
IN 6
IN 7
IN 8
Reel Enable/Disable Switch
Engine Speed Switch − Increase
(Yanmar diesel engines)
IN 9
IN 10
IN 11
Engine Speed Switch − Decrease
(Yanmar diesel engines)
IN 12
ANALOG IN 5
Hydraulic Oil Temperature Sender
Engine Temperature Sender
ANALOG IN 6
Electrical System
Description
Neutral Switch
Seat Switch
Joystick Raise Switch
Joystick Lower Switch
− OR −
Engine Oil Pressure
(Kubota diesel engines)
Front Backlap
Rear Backlap
− OR −
Alternator
(Kubota diesel engines)
(Kubota diesel engines)
1. Toro Electronic Controller
The TEC controls electrical output to the following out-
puts:
Output
Number
OUT 1
OUT 2
OUT 3
OUT 4
OUT 5
OUT 6
OUT 7
Fan Speed Proportional Valve (PRV)
OUT 8
OUT 9
OUT 10
OUT 11
OUT 12
Cutting Units Lift and Lower (enable)
OUT 13
OUT 14
Page 6 − 38
Figure 31
Description
Engine ECU (Yanmar engine)
− OR −
Start Relay (Kubota engine)
Fuel Pump and
Engine ECU (Yanmar engine)
− OR −
Fuel Stop Solenoid Hold Coil
(Kubota engine)
Fan Direction Solenoid Valve (S1)
Front Cutting Units
Lift and Lower Solenoid Valve (S4)
Front Cutting Units Engage
Proportional Valve (SP1)
Rear Cutting Units Engage
Proportional Valve (SP2)
Not Used
Rear Cutting Units
Lift and Lower Solenoid Valve (S5)
Cutting Units
Lift or Lower (direction)
Solenoid Valve (S2)
Glow Relay (Kubota diesel engines)
Not Used
Solenoid Valves (S1 and S3)
HIGH/LOW (transport/mow)
Range Solenoid Valve
Reelmaster 7000−D
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

0378003780a03781

Table of Contents