APPENDIX
Appendix 1
The input/output signal and buffer memory of C24 can be set by using module label.
Module label configuration
A name of module label is defined in the configuration below:
"Instance name"_"Module number"."Channel number"."Label name"
"Instance name"_"Module number"."Label name"
"Instance name"_"Module number"."Channel number"."Label name"_D
"Instance name"_"Module number"."Label name"_D
Ex.
C24_1.stnCH1.uSet_ReceivedDataCount_Reception_D
■Instance name
The instance name for RJ71C24(-R2/R4) is "C24".
■Module number
A module number is a number starting from 1, which is added to identify a module that has the same instance name.
■Channel number
A channel number is a number added to the module label corresponding to a buffer memory other than the CH1/CH2
common area.
For module label corresponding to a buffer memory other than the CH1/CH2 common area, the following content is added as
the channel number.
Channel number
CH1
CH2
■Label name
This is a module unique label name.
■_D
This indicates that the module label is for direct access. Without this symbol means a label for refresh. There are some
differences between refresh and direct access as shown below.
Type
Refresh
Direct access
APPENDICES APPENDIX
492
Appendix 1 Module Label
Module Label
Description
Values written to/read from a module label are reflected to the module in batch at the time of
refresh. This shortens program execution time.
Values written to/read from a module label are immediately reflected to the module. Although the
program execution time is longer than refresh, the responsiveness will be increased.
Content to be added
stnCH1
stnCH2
Access timing
At the time of refresh
At the time of writing to/
reading from module label