Mitsubishi Electric MELSEC iQ-R Series User Manual page 131

■Transmission instruction of device information and programmable controller CPU status
information when transmitting the monitoring results
Use the following dedicated user frame numbers.
Frame No. Information to be transmitted
B001H Device information for the block registered in
number n
B002H
B003H
B004H
B005H
B006H
B007H
B008H
B009H
B00AH
B061H Programmable controller CPU status information (CPU error
monitoring data)
B080H Number of blocks to be sent
B081H Monitoring result information for all blocks
B082H Monitoring result information for blocks satisfying the conditions
■Device information and programmable controller CPU status information
It is transmitted in the order of data shown below.
Page 130 Data arrangement of device information and programmable controller CPU status information
For ASCII-BIN conversion, set "ASCII-BIN conversion designation" to "ON".
When user frame is designated with the number, of which bit 14 for the numeric value indicating the user frame number is ON,
ASCII-BIN conversion of the corresponding send data is not performed. It will be transmitted as binary data. (Page 348
ASCII-BIN Conversion for Data Communicated with Nonprocedural Protocol)
Number 1
Number 2
Number 3
Number 4
Number 5
Number 6
Number 7
Number 8
Number 9
Number 10
6 USING THE PROGRAMMABLE CONTROLLER CPU MONITORING FUNCTION
6.2 Programmable Controller CPU Monitoring Function
Valid function
Fixed cycle send Condition match send
 
 
 
 
6
129