Command Diagnostic Messages; Commands; C0100 Communication Phase 3 Transition Check; C0200 Communication Phase 4 Transition Check - Bosch Rexroth IndraDrive Troubleshooting Manual

Rexroth IndraDrive
9

Command Diagnostic Messages

9.1

Commands

C0100 Communication phase 3 transition check

C0200 Communication phase 4 transition check

DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Note: Each command that was started by a control unit must be
actively cleared again.
See also "Basic Functions of Master Communication, Command
Processing"
Supported by Firmware Variant:
Supported by Supply Unit:
The S-0-0127, C0100 Communication phase 3 transition check
command was activated.
Note: This status is displayed on the control panel of the drive with
"C01".
C0100 - Attributes
Display: C01
Mess. no.: C0100 (hex)
Supported by Firmware Variant:
Supported by Supply Unit:
The S-0-0128, C0200 Communication phase 4 transition check
command was activated.
Note: This status is displayed on the control panel of the drive with
"C02".
C0200 - Attributes
Display: C02
Mess. no.: C0200 (hex)
Command Diagnostic Messages
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
HMV01
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
HMV01
9-1