Hitachi FL.NET User Manual page 106

Figure 5-39 Transparent Receiving Flag Area and Transparent
The table below shows the acceptable input ranges for the setup items.
Input item
Transparent reception
task
Transparent reception
task's factor
Transparent receiving
flag area
Note: The symbols selectable for a transparent receiving flag area are the same as for a LPU
memory area. Also, note that a transparent receiving flag area setting must not be a
duplicate of any of those for the other set areas.
Enter the starting address for the
transparent receiving flag area.
Reception Task Setup Window
Description
Task number of the task that is to start
upon receipt of a transparent message.
Factor for starting a transparent
reception task.
This area reports a transmission source
node number when a transparent
message is received (the area size is 16
words).
Acceptable setting range
The acceptable setting ranges from 1 to
255. Because 230 to 255 are used by the
system, they are not started.
0 to 32
See Table 5-6, "Address Ranges for
Common Memory Area Allocation in
LPU Memory."
5-51
5 USER GUIDE
Enter the settings
for the transparent
reception task and
transparent
reception task's
factor.