Joining Other Nodes Information - Hitachi FL.NET User Manual

(6) The item whose setup has been changed is displayed in a different color.
Self-node
(7) If the node number to be displayed is not found on the window, click the
buttons to shift the display.
▼
▼
▼
(8) After completing the setup, click the
Cancel button.
The data of the self-node (Node No.1 in the above figure) is displayed in shadow form and
the setup cannot be changed. Change it on the Self-node setup or [[Online] Self-node
information] window (see "5.5.1 Self-node information").
If the FL.NET system is running in online mode, clicking the
the FL.NET module to automatically isolate itself from the network and have the
parameters written to the actual target machine. Upon completion of the writing, the
FL.NET module will automatically join the network again according to the written
parameters.

5.5.4 Joining other nodes information

Function: Monitor the information on other nodes that join the network, and set PCs allocation.
For using this function, it is a prerequisite that the PCs is connected with the PC by cable.
Operation: The procedure is shown below.
(1) When the FL.NET system is running in online mode, choose [Main] or [Sub] from the
[Module] menu in the [[S10V] FL.NET] window.
(2) Select the [Network] menu.
(3) The [All Networks] icon and each node No. icon (red or blue) connected to the network are
displayed. The red node No. icon indicates the self-node. The blue node No. icon
indicates other node connected to the network.
When the setup has been
changed, its color changes.
Write button. To cancel the setup, click the
5-127
5 USER GUIDE
▲
and
▲
▲
Write button causes