Error Indications And Countermeasures - Hitachi FL.NET User Manual

7.4 Error Indications and Countermeasures

(1) Tool's error indications
For error indications given by the tool, see "5.5.7 RAS information."
(2) Error log information to the LPU module
The collected error information in the LPU module can be referenced from [Error log] of
[S10V BASE SYSTEM]. For details, refer to "S10V USER'S MANUAL BASIC
MODULES (manual number SVE-1-100)."
[FA protocol errors]
When an error stated in the FA protocol is detected during an FL.NET module operation, the LPU
unit module shows a error code as recorded in Table 7-2.
The FL.NET module may stop running in compliance with the FA protocol, depending on the
contents of the displayed message.
[Hardware errors]
When the FL.NET module detects a hardware error, the LPU unit module shows an error code in
record with Table 7-2. The FL.NET module also illuminates the error LED and operation comes
to a stop.
If a checksum error occurs in the contents of parameter setup, this results in a parameter error.
When this parameter error occurs, open the Parameter setup screen of the installed model and
change the setup as required.
7-7
7 TROUBLESHOOTING