Hitachi FL.NET User Manual page 20

Thank you for purchasing the FL.NET module, which is an option for use with the S10V.
This manual, named "USER'S MANUAL OPTION FL.NET," describes how to use the
FL.NET module. For proper use of the CPU link module, it is requested that you thoroughly read
this manual.
The S10V product is available in two types: standard model and environmentally resistant model.
The environmentally resistant model has thicker platings and coatings than those for the standard
model.
The model number of the environmentally resistant model is marked by adding the suffix "-Z" to
the model number of the standard model.
(Example) Standard model: LQE702
Environmentally resistant model: LQE702-Z
This manual is applicable to both the standard model and environmentally resistant models.
Although the descriptions contained in this manual are based on the standard model, follow the
instructions set forth in this manual for proper use of the product even if you use the
environmentally resistant model.
<Precautions on the FL-net protocol version>
For the FL-net protocol, Ver. 1.00 and Ver. 2.00 are available. These versions are not
compatible and a Ver. 100 device and a Ver. 2.00 device cannot be connected to each other.
Note the protocol version that the FL.NET module can support varies depending on the model.
The FL-net protocol version for each model is shown below.
Do not connect an FL-net protocol Ver. 1.00 device to a Ver. 2.00 device. The FL-net protocol
Ver. 2.00 device has a function that prevents participation in the data link when an FL-net protocol
Ver. 100 device is detected on the network. Accordingly, the Ver. 1.00 device and Ver. 2.00
device cannot configure a data link.
Model
FL-net protocol version
PREFACE
LQE500 LQE502/LQE702
Ver. 1.00
i
Ver. 2.00