Table of Contents
Advertisement
GE H
EALTHCARE
D
FL091021, R
IRECTION
4-2-5-2
Install MO Disk in MO Drive
Never move the unit with a MO disk in the Magneto Optical Disk Drive because the drive actuator
NOTICE
will not be locked and the Magneto Optical Disk Drive could break.
1.) Preparations before installing an MO disk in the MOD Drive:
a.) The unit must be turned ON and "up and running" before using the MOD Drive
b.) Verify the MO disk for loose hardware or damaged labels which could jam inside the MOD
c.) Ensure that the slide switch in one corner of the disk is set so that the disk is write enabled
2.) Insert the disk into the MO Disk Drive with the label for the side you intend to use, facing up.
4-2-5-3
Eject and Remove MO Disk from MOD Drive
Do not eject the MO Disk using the button on front of the MO drive.
NOTICE
In some cases, the MO Disk is ejected automatically. If not automatically ejected, use the manual
ejection method as described in the following steps:
1.) Select the Eject button on the screen
OR
Press <Alt> + E on the alphanumeric keyboard to display the Eject Device menu.
2.) Select 5 1/4 MO Disk in the Eject Device menu to eject the MO Disk.
3.) Remove the ejected MO Disk from the MO Drive and place it in its cover box for storage in a safe
place.
4-2-5-4
Installing DVD/CD into DVD/CD Drive
NOTE:
IMPORTANT: Use only CD-R, DVD-R or DVD+R media from a reputable vendor and only
high-grade media types.
1.) Press the Eject button on the right side of the DVD/CD Drive once to open the disk tray.
2.) Put a DVD/CD disk into the disk tray with the label side facing up.
3.) Press the Eject button once to close the disk tray.
After a few seconds, the disk is available for reading, formatting or writing, depending on the type
of disk you used.
4-12
5
EVISION
Drive.
(disk hole closed).
Figure 4-6 Eject Device Menu
Section 4-2 - General Procedures
V
S
M
IVID I N
ERVICE
ANUAL
Advertisement
Table of Contents
