Table of Contents
Advertisement
GE H
EALTHCARE
D
FL091021, R
IRECTION
8-2-2-5
Hard Disk Installation Procedure
NOTE:
When replacing the BEP or Hard Disk, one must either obtain new access codes that will fit the
system ID which is programmed on the BEP, or program the BEP system ID to fit the access codes
already registered in the Hard Disk. Only qualified personnel should perform these tasks.
1) Place the new hard disk in position in the hard disk module holder - see Figure 8-4 on page 8-4 .
2) Return and fasten the two screws (previously removed) to secure the Hard Disk in position - refer
to Figure 8-3 on page 8-4 .
Note:
When a new hard disk arrives from the manufacturer, usually it is partitioned and ready for
software installation.
Refer to
Note:
IMPORTANT - if both the Hard Disk and Back End are being replaced simultaneously, it is
necessary to re-configure the LCD type. Refer to the instructions provided in
page 8-48 through
3.) Proceed to perform the following functionality tests:
-
-
-
5
EVISION
"Software Loading" on page 8-56
step 12
on page 8-49.
"Chassis Current Leakage Test" on page 10-25
"Calibration Tests" on page 7-15
"Full System Test" on page 7-9
Chapter 8 - Replacement Procedures
for software installation instructions .
V
S
M
IVID I N
ERVICE
ANUAL
step 9
on
8-5
Advertisement
Table of Contents
