Table of Contents
Advertisement
GE H
EALTHCARE
D
FL091021, R
IRECTION
8-3-3-5
BEP Installation Procedure
1) Carefully return the new BEP to the original position on the Bottom Assembly - refer to Figure 8-35
on page 8-35 .
Note: When replacing the BEP or Hard Disk, one must either obtain new access codes that will
fit the system ID which is programmed on the BEP, or program the BEP system ID to fit the
access codes already registered in the Hard Disk. Only qualified personnel should perform
these tasks.
2) Check that the BEP is seated correctly then return and fasten the four screws (previously removed)
to secure the BEP to the Bottom Assembly - refer to Figure 8-34 on page 8-35 .
3) Re-connect all the cables to the BEP:
Proceed as follows (refer to Figure 8-33 on page 8-34 ):
a.) Re-connect the Speaker-to-BEP power cable
b.) Re-connect the Fan-to-BEP power cable.
c.) Re-connect the HVPS-to-BEP power cable.
d.) Re-connect the BEP-to-RFI Flex cable.
e.) Re-connect the LCD Flex ribbon cable (carefully push back and secure the two connector
4) Return the Control Panel and Keyboard, as described in the
Installation Procedure" on page
5) Return the Hard Disk, as described in the
6) Make sure the Vivid i n LCD Display cover is securely closed and place the scanner face down. Re-
install the battery as described in the
7.) Make sure there is no T-plug (dongle) or any other peripheral connected to the USB or PCMCIA.
8.) Turn ON the system and boot-up.
9.) Perform the BIOS Update procedure, as described in
Note:
If both the Back End and the Hard Disk are being replaced simultaneously, continue to the
next step. If only the Back End is being replaced, skip
10) Perform the steps required to burn the LCD type onto the newly-installed Back End, as described
in
step 9
11) Perform a complete functional check of the system, as described in
and Functional
8-36
5
EVISION
latches).
on page 8-48 through
Checks.
Section 8-3 - Internal Component Replacement Procedures
8-8.
"Hard Disk Installation Procedure" on page
"Battery Installation Procedure" on page
"BIOS Firmware Update" on page
step 10
step 12
on page 8-49.
V
S
IVID I N
ERVICE
"Control Panel and Keyboard
8-3.
and proceed to
step
11, below.
Chapter 4
-
General Procedures
M
ANUAL
8-5.
8-79.
Advertisement
Table of Contents
