Table of Contents
Advertisement
GE H
EALTHCARE
D
FL091021, R
IRECTION
8-4-7
Full Re-ghost and Software Installation
NOTE:
During software installation, all peripherals should be removed - including PCMCIA devices (but
excluding the DVD\CD-RW driver).
IMPORTANT It is recommended to store partition C:\ by using the Rollback tool (described in the
NOTICE
"Vivid i nSoftware Roll-back Procedure" on page
1) Connect the DVD\CD-RW to the USB port at the rear of the system.
2) Connect power to the DVD\CD-RW drive.
3) Place the CD containing the full software version into the DVD\CD-RW drive and close the tray.
4) Turn ON the Vivid i n system and allow it to boot-up from the GHOST CD.
The system powers ON and when system boot-up from the CD is complete, the following options
are displayed in the DOS screen, prompting you to select the required option:
5) If this is first installation, format the hard disk as described in
Disk - Automatic Procedure" on page
6) Select option: 1: Vivid_i Full Clean Install (System + Application Software)
A menu will appear prompting for selection of the required option:
7) Select option A: Install Software
The system will prompt you to type in the service password.
8) Type: geulsservice and press <Enter>.
The software ghosting will take approximately 15 minutes.
IMPORTANT: Do not stop the software installation operation during this process!
8-88
5
EVISION
Section 8-4 - Software Loading
8-96) after full software installation or upgrade.
"Formatting and Partitioning the Hard
8-82. When done, proceed to the next step, below.
V
S
M
IVID I N
ERVICE
ANUAL
Advertisement
Table of Contents
