GE Voluson E8 Service Manual page 307

GE H DRAFT
EALTHCARE
D KTD102576, R
IRECTION
CPS_InterfaceToHW::vSet_VOL_MODE -- incorrect value for LongLineMemFIFO
CPS_InterfaceToHW::vSet_VOL_MODE -- incorrect value for Mode_4D
CRI: mismatch in steering angle header info
Action: restart the system
CtrlMvGrpRepresentations::isInWriteMode not supported for mode nr xx
CVIE parameter file could not be created
CW Archive::not implemented Action: restart the system
CW quant TX Frequ out of range
CW_BaseLinePos Out Of Range
CW_Gain Out Of Range
CW-hardware doesn't support
CW-TxFrequency == 0
D:\\SERVICE\\ConfIndexFile is corrupted Action: restart the system
Data are not saved or sent to DICOM Server!
dDistanceFocusReferenceBF_ToProbeSurface out of valid range Action: restart the
system
Delete error (Backup data could not be deleted.)
Density Out Of Range
Device is not a DVD/CD rec.
Different software error (Backup data was made on another system with a different
software version.)
Disc is full!
Display:Rect Region fails
Do you really want to delete?
Do you really want to format this DVD?
done is low!
Doppler-Txfrequency out of range
Downgrade error (Backup data was made with a software version higher than the
installed version.)
DVD recorder communication error! Check recorder cables and try again.
Make sure DVD recorder is connected to US machine.
DVD recorder not properly connected or turned off!
Check connection from US system to recorder, recorder has power and is on.
7 DRAFT (A
EVISION
Error Messages
Chapter 7 - Diagnostics/Troubleshooting
23, 2012)
UGUST
restart the system
restart the system
restart the system
restart the system
restart the system
restart the system
restart the system
press ok and save this user-setting once again
press ok and save this user-setting once again
pencil probe + CW-Hardware not available->
restart the system
restart the system
restart the system
restart the system
restart the system
check storage destination of Full Backup
(e.g., DVD/CD, insufficient rights on target Network drive,
write protection on USB-drive)
press ok and save this user-setting once again
reconnect the device
This backup cannot be restored by the user.
use a new CDR for writing data to CD
restart the system
restart the system
restart the system
load appropriate backup for installed version
check DVD connections, check if DVD is switched on
check DVD connections, check if DVD is switched on
V E8 / V
OLUSON OLUSON
S M
ERVICE ANUAL
Actions
7-35
E6