Adjustment Of The Vga Image Resizer Settings - GE Voluson E8 Service Manual

GE H RAFT
EALTHCARE
D KTD102576, R
IRECTION
3-5-7-1

Adjustment of the VGA Image Resizer Settings

To get the best results in image quality out of this Resizer Box you should make the following settings.
1.) Set the output resolution of the Image Resizer to the native resolution of the monitor:
a.) Press the MENU key at the Image Resizer and use + (plus) and - (minus) key to navigate to
b.) Press the MENU key to enter the sub menu output setup, press the MENU key again to
c.) Choose mode with + and - key.
d.) Navigate to menu item Exit and press MENU key to leave the On Screen Menu.
NOTICE
Changes get effective immediately. If monitor is not showing anything after a change, your setting might
be wrong. To reset the Image Resizer in case that anything went wrong, press either the MENU and -
!! NOTICE:
key or the + and - key until the image reappears. Try other settings that are supported by your monitor.
2.) Use high quality Video cables especially for longer distances. High quality cables improve overall
image quality due to lower sensitivity on electromagnetic interferences.
3.) Set Brightness & Contrast for best and detailed image display.
a.) Press MENU key, select Picture Adj. using the On Screen Menu.
b.) Select first item Cont. (means contrast) by pressing the MENU key and adjust it (using + and
c.) Navigate to Bright. (means brightness) and press MENU key again to highlight item.
d.) Set brightness to any value you think it results in the best quality image for your monitor and
NOTE: You may change the Color setting in the same way if you think adjustment is necessary.
e.) When everything is done, navigate to Exit and press MENU key to leave the On Screen Menu.
3-24
7 DRAFT (A
EVISION
Figure 3-19 keys on Image Resizer
Output Setup using the On Screen Menu.
highlight the Mode Setting.
When correct mode is displayed press MENU key to activate the setting.
- key) until you think you get the best result on your monitor and then press the MENU key.
then press the MENU key.
Section 3-5 - Connection of Auxiliary Devices
23, 2012)
UGUST
V E8 / V
OLUSON OLUSON
S M
ERVICE ANUAL
E6