ABB ACS580MV Commissioning Manual page 132

132 Option
1. General configuration of Master
Parameter Name
19.11 Ext1/Ext2 selection
19.12 Ext1 control mode
60.1 M/F comm port
60.2 M/F node address
60.3 M/F mode
60.9 M/F comm loss function
60.10 M/F ref1 type
60.11 M/F ref2 type
60.17 Follower fault action
60.14 Follower nodes
61.1 M/F data 1 selection
61.2 M/F data 2 selection
61.3 M/F data 3 selection
62.4 Follower node 2 data 1 sel
62.5 Follower node 2 data 2 sel
62.6 Follower node 2 data 3 sel
62.7 Follower node 3 data 1 sel
62.8 Follower node 3 data 2 sel
62.9 Follower node 3 data 3 sel
62.10 Follower node 4 data 1 sel
62.11 Follower node 4 data 2 sel
62.12 Follower node 4 data 3 sel
25.8 Drooping rate
2. General configuration of Torque Follower
Parameter Name
19.11 Ext1/Ext2 selection
19.14 Ext2 control mode
ACS580MV Master Parameter Settings
Setting
Ext1
Speed
RDCO CH2
0 or 1
DDCS master
Fault
Speed
Torque
Fault
User dependent
CW 16bit
Other P23.2
Torque reference
used
Follower SW
User dependent
Follower SW
User dependent
Follower SW
User dependent
User dependent
ACS580MV Follower Parameter Settings — Torque Follower
Setting
Ext2
Torque
Description
Channel of DDCS M/F
Master's action when comm loss
happens
Ref1 is used for speed control
Ref2 is used for torque control
Master's action when Followers have
fault
(optional) Master selects the Followers
which need to be surveilled, and the
related Follower node data sel need to
be set (P62.4~10)
Master selects the data which transmit to
the Followers. The data value shown as
P61.25~27
(Optional)
Master selects the data which receive
from the Followers. The data value
shown as P62.28~36
Defines the droop rate (in percent of the
motor nominal speed)
Description