Address Setting - Fujitsu AIRSTAGE J-IIIL Design & Technical Manual

¢ Remote controller setting
(Only for Wired remote controller and Simple remote controller.)
Dual remote controller setting

1-2. Address setting

Address for each unit should be preset before starting system operation. Refer to
Chapter 6. SYSTEM DESIGN on page 06-1 to confirm the details of each unit, and perform the set-
ting.
¢ Outdoor unit addresses and setting ranges
Setting
Refrigerant circuit
A
address
Terminal resistor
1-1. System type setting
Set the SW2 of DIP switch 1.
For details, refer to
Setting
Type of switch
range
Setting example
00—99
01
ON/OFF
- (07-3) -
"Function settings"
Arbitrary numbers can be set in
range of 00—99.
REF AD REF AD
x10 x1
DIP switch SET5-4
Refer to
setting"
SET5
on page 07-59.
"System design" in
Remarks
"Terminal resistor
on page 07-56.
1. System settings