Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 619

 Indoor unit address setting
1. In the function setting mode display, press the MODE button to enter the address setting mode.
2. Make sure that the function number displayed on the remote controller LCD is "01". If the num-
ber is other than "01", press the SET TEMP.
3. Press the FAN button to enter the address data setting mode. The address data will flash when
this button is pressed.
4. Press the SET TEMP.
is between "00" and "63".
Each time the MODE button is pressed, it switches between the left digit and the right digit.
1-4. Address setting by remote controller
or
Address data
or button to adjust the address data. The indoor unit address range
Range
00 to 63
: Up
: Down
- (07-19) -
button to change the number.
Set at "01"
Change digit
1. System settings