Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 651

3. When "F3" is displayed on the LED104, press the ENTER button (SW109). Indicator on the
LED105 flashes.
LED105
4. Press the SELECT button (SW108) to display "10" on the LED105.
LED105
5. When "10" is displayed on the LED105, hold down the ENTER button (SW109) for 3 seconds
or longer. (Unless it is held down for at least 3 seconds, the selection will not be confirmed.)
When the automatic address setting function is activated, the display changes to "run."
LED105
6. When the automatic address setting is completed, the number of signal amplifier is displayed
on the LED104. Verify that the count matches the number of signal amplifiers being installed.
LED105
7. To exit the automatic address setting, press the ENTER button (SW109) in the setting complet-
ed status shown in the previous step.
LED105
8. To exit the function mode, press the MODE/EXIT button (SW107).
LED105
RELATED LINKS
"Signal amplifier" on page 07-119
1-5. Automatic address setting
LED104 LED105 LED104
LED104 LED105 LED104
LED104 LED105 LED104
Example: When 8 signal amplifiers are being connected
LED104
LED105 LED104
LED104 LED105 LED104
LED104
LED105 LED104
- (07-51) -
1. System settings