Table of Contents
Advertisement
2.2.2
Transporting the Robot
In principle, the robot should be transported in the state shown in Fig. 2.2 or Fig. 2.4
above. Fold back and secure the arm with the attached clamp. (The robot is
shipped in this posture. After you have unpacked the shipment, you should move it as
it is.) At this time, take careful precautions not to impose a large force on the tool
shaft.
•
Be sure to secure the arm with the attached clamp before transporting the
robot. Failure to do so could cause a hazardous situation as the arm will
move when the robot is lifted.
It is possible to lift up and transport the robot. Pass the wire through the attached
eyebolt, then lift up the robot carefully, as shown in Fig. 2.5. This figure shows the
TH850A.
TRANSPORTATION AND INSTALLATION MANUAL
!
DANGER
Fig. 2.5 Lifting up the robot
– 19 –
Wire
STE80753
Advertisement
Table of Contents
