Moving To Other Groups - LG SV-iC5 Series Instruction Manual

5.3

Moving to other groups

There are 4 different parameter groups in SV-iC5 series as shown below.
Drive group
Drive group
Function group 1
Function group 2
I/O (Input/Output)
group
Moving to other parameter groups is only available in the first code of each group as
the figure shown below.
Moving to other groups using the Right ( ) key
I/O group
*
Target frequency can be set at 0.0 (the 1
The changed frequency will be displayed after it is changed.
Function
group 1
Basic parameters necessary for the inverter to run. Parameters such as Target
frequency, Accel/Decel time are settable.
Basic function parameters to adjust output frequency and voltage.
Advanced function parameters to set parameters for such as PID Operation
and second motor operation.
Parameters necessary to make up a sequence using Multi-function
input/output terminal.
*
Drive group
Function
group 1
Function
group 2
st
code of drive group). Even though the preset value is 0.0, it is user-settable.
Function
group 2
I/O group
Moving to other groups using the Left ( ) key
I/O group
5-3
5. Programming keypad
*
Drive group
Function
group 1
Function
group 2
SV-iC5