Can Teamwork + Fe Monitoring - Huawei FusionCol8000-C210 User Manual

FusionCol8000-C210 In-room Chilled Water Smart
Cooling Product
User Manual
If the length of a network cable in the FE teamwork is greater than or equal to
100 m, use the group-based ring networking mode.
1.
2.
3.
Figure 4-31 FE teamwork group-based ring networking (using 13 units as an
example)
----End

4.6.4 CAN Teamwork + FE Monitoring

Step 1 Connect teamwork and monitoring communications cables.
Networking
Protocol
Description
Issue 05 (2022-12-15)
Connecting units with odd numbers: Connect the FE_1 port of the unit with
an odd number to the FE_2 port of the unit with the next odd number.
Connecting units with even numbers: Connect the FE_2 port of the unit with
an even number to the FE_1 port of the next unit with an even number.
Connect FE_2 of No. 1 unit and FE_1 of No. 2 unit, and connect the remaining
FE_1 and FE_2 of the last two units.
CAN Teamwork
CAN
One teamwork network
supports a maximum of 32
units. On the Teamwork
Settings screen of the display
modules of the first and last
units, set Enable teamwork
CAN resistor to Yes.
NO TE
If the Modbus-TCP/SNMP protocol is used, customers can purchase the NetEco (a LAN
switch is required) or a third-party NMS as the monitoring system.
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 System Installation
FE Monitoring
Modbus-TCP/SNMP
-
64