Hitachi WJ200 Series Quick Reference Manual page 22

Parameters and functions in the diagram
When Func. code is not displayed, change b037(Function code display restriction) from 04 (basic display) to 00 (Full
display).
Group "d"
Func. code display




Group "F"
Func. code display




Group "A"
Func. code display





Group "b"
    
→ → → →
NOTE: Pressing the [ESC] key will make the display go to the top of next function group,
regardless the display contents. (e.g.   [ESC]  )
Func. code display
SET
SET

Func. code display
ESC
ESC
SET

Data display
Data does not blink because of real time synchronizing
ESC
SET

ESC
Data display
When data is changed, the display
starts blinking, which means that
new data has not been activated yet.
  
→ → →
Press the both up and down key at the same

time in func. code or data display, then

single-digit edit mode will be enabled.
Refer to 2-34 for further information.
: Moves to data display
.
ESC
: Jumps to the next group
Save
.
SET ESC
.
SET ESC
(F001 to F003)
SET
: Saves the data in EEPROM
and returns to func. code
ESC
: Returns to func. code display without saving data.

SET ESC

SET ESC
SET : Saves the data in EEPROM and
returns to func. code
ESC : Cancels the data change and
returns to func. code display.
16
display.
display.