Hitachi WJ200 Series Quick Reference Manual page 56

Main Profile Parameters
NOTE: Marking [  ],[  ],[
 : Configuration changes are possible during operation.
: You cannot change the parameters during operation.
*
1: In case of (b031) soft lock selections"10", parameter changing during operation is
possible.
Func.
Code
Output frequency setting
F001
Acceleration time (1)
F002
F202 Acceleration time (1),
nd
2 motor
F003 Deceleration time (1)
F203 Deceleration time (1),
nd
2 motor
F004 Keypad RUN key routing
*
1 ],in the table show following meaning.
" F " F u n c t i o n
N a m e
Standard default target frequency
that determines constant motor
speed, range is 0.0 / start
frequency to maximum frequency
(A004)
0.0 to 100.0[%] if enables PID
Standard default acceleration,
range is 0.00 to 3600 s.
Standard default deceleration,
range is 0.00 to 3600 s.
Two options; select codes:
00 Forward
01 Reverse
D e s c r i p t i o n
50
Run D e f a u l ts
Mode I n i t i a l
U n i ts
Edit d a ta

0.00

10.0

10.0

10.0

10.0

00
Hz
s
s
s
s
