NEC PA1705UL-W Installation Manual page 13

Power cord
Handling the power cord
• The projector should be installed close to an easily accessible power outlet.
• When connecting the power cord to the projector's AC IN terminal, make sure
the connector is fully and firmly inserted. Be sure to fix the power cord using
REQUIRED
the power cord stopper. Loose connection of the power cord could lead to
fire or electric shock.
Handling the power cord by following below to avoid fire or
electric shock
• When connecting or disconnecting the power cord, pull the power cord out
by holding onto its plug.
• Unplug the power cord from the power outlet before cleaning the product
REQUIRED
or when not planning to use the product for an extended time.
• When the power cord or plug is heat or damaged, unplug the power cord
from the power outlet, and contact your dealer.
UNPLUG THE
POWER CORD
Periodically clean dust and other debris from the power plug
• Failure to do so could result in fire or electric shock.
REQUIRED
Disconnect power cords and other cables before moving the
projector
• Before moving the product, make sure the product power is off, then unplug
the power cord from the power outlet and check that all cables connecting
the product to other devices are disconnected.
REQUIRED
Do not use the power cord with a power tap
• Adding an extension cord may lead to fire as a result of overheating.
PROHIBITED
CAUTION
xii
Important Information