NEC PA1705UL-W Installation Manual page 17

Laser Safety Caution
WARNING
CLASS 1 LASER PRODUCT OF IEC 60825-1:2014
CLASS 1 CONSUMER LASER PRODUCT OF EN 60825-1:2014+A11:2021 (For EU and UK)
• The laser module is equipped in this product. Use of controls or adjustments of procedures
other than those specified herein may result in hazardous radiation exposure.
Laser energy exposure near aperture may cause burns.
• This product is classified as Class 1 of IEC60825-1:2014.
• For EU and UK, EN 60825-1:2014+A11:2021 and EN 50689:2021 are also conformed.
Except using the lens of NP55ZL and NP56ZL.
• Obey the laws and regulations of your country in relation to the installation and management of
the device.
For USA
Complies with 21 CFR 1040.10 and 1040.11 except for conformance as a Risk Group 2 LIP as
defined in IEC 62471-5:Ed. 1.0. For more information see Laser Notice No. 57, dated May 8, 2019.
However, when using the NP55ZL and NP56ZL lenses, the following applies.
This product is in conformity with performance standards for laser products under 21 CFR 1040,
except with respect to those characteristics authorized by Variance Number 2018-V-4413 effec-
tive on March 1, 2019.
WARNING
• Do not allow to look into the projector beam at any distance from the projector. An adult
should supervise the children to prevent exposure risks.
• Check that there is no one looking at the lens, when using the remote control for starting the
projector.
• Do not look at the projected light using optical devices(binoculars, telescopes, magnifying
glasses, reflectors, etc).
• [ WARNING: MOUNT ABOVE THE HEADS OF CHILDREN. ]
The use of a ceiling mount is recommended with this product to place it above the eyes of
children.
• Outline of laser emitted from the built-in light module:
- Wave length: 455 nm
- Maximum power: 390 W (PA1705UL-W/PA1705UL-B), 346 W (PA1505UL-W/PA1505UL-B)
Light Module
• A light module containing multiple laser diodes is equipped in the product as the light source.
• These laser diodes are sealed in the light module. No maintenance or service is required for the
performance of the light module.
• End user is not allowed to replace the light module.
• Contact qualified distributor for light module replacement and further information.
xvi
Important Information