Table of Contents
Advertisement
Removing
1. Turn the two option cover A screws counterclockwise until it turns loosely.
•
The screws are not removable.
2. Remove the option cover A.
Hold up the option cover A to release its two hooks from projector tilt foot.
3. Attach the two corner caps to the projector.
• Option cover B
Mounting
1. Press the two protrusions on option cover B
against the slits in the projector's exhaust
vent.
•
Line up the upper protrusion with the slit
at the very top, the lower protrusion with
the slit at the very bottom.
2. Supporting option cover B by hand, turn
the two screws clockwise to tighten them.
•
Tighten the screws securely.
Removing
1. Supporting option cover B by hand, turn the two screws counterclockwise to loosen them
until they turn freely.
•
The screws are not removable.
2. Remove the option cover B.
6. Attachment/detachment of parts sold separately
a: Screw hole
151
a
Advertisement
Table of Contents
Troubleshooting
