Pioneer QUANTUM INVERTER Series Service & Troubleshooting Manual page 101

3.2.3. Electronic Control Box Subassembly Removal (EW-4)
Procedure
1) Release the hooks, and then open
the cover (4 hooks total)(see Fig. 1).
2) Remove 6 screws on the electronic
control board and then remove the
electronic control box subassembly
(see Fig. 2).
Note: Electric control box cover
cannot be removed.
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
.
Outdoor Unit Disassembly

Scope of Models Covered:
YN030GMFI20RPD / YN036GMFI20RPD
Figure 1
Figure 2
18
